Tip 1 Vacuuming

The dry soil types are easily removed by vacuuming.  As long as they are removed on a daily basis, it will help to minimize the damage to the carpet. Regular thorough, deep vacuuming is surely the most important step when it comes to carpet care.  While non-traffic areas can be vacuumed quickly major traffic areas should be vacuumed in more than one direction as you run the vacuum slowly giving it time to pick up the deeper soil. Not all vacuum cleaners are equal and a good quality vacuum will do a better job of cleaning. A good quality vacuum is not necessarily the most expensive. Visit some of the websites at the Carpet and Rug Business Directory to learn more about vacuums that they have tested.

Tip 2 Walk Off Mats

Keep those dry and gritty outdoor soils from being tracked on to your wall to wall carpet. One of the best and easiest ways to do this is to use walk off mats and area rugs at entrances. Always use entrance mats outside of your doors and make sure that anyone who enters your home use the mats to help get debris and dirt off of their shoes before they enter. Where possible also use an area rug or walk off mat inside your door to help trap soil missed by the outside mats. All mats and rugs need to be vacuumed and cleaned regularly so that they are trapping dirt and not placing dirt on to your shoes.

Tip 3 Shoes

Many people prefer that their family and guest go shoeless on their carpet. This can be helpful, especially if you have slippers that are only worn indoors that you slip into upon entering.  The oils from oily bare feet will transfer from ones feet to the carpet.

Tip 4 Pets

If you have pets you need to understand that oil does transfer from pet hair to carpet. Placing an area rug in areas where your pets like to lay will provide excellent protection for your carpet.

Tip 5 Spots and Spills

Keep your eye out for spills and take care of them in a quick manner to keep your carpet clean.  Most spots and spills can be easily cleaned by blotting with no more than clean tap water and a towel. If water does not work you will need to use a cleaning product for the specific type of spot you are experiencing problems with.  See Spot Cleaning Chart.

Tip 6 Deep Cleaning

Have your carpet professionally deep cleaned before it becomes too soiled.  A good thorough cleaning for your higher traffic areas should be performed at least every 12 to 18 months. See More on Cleaning Methods

A well maintained home and clean carpet will not only add value to your home it will also extend the life of your carpet, protect your carpet warranty, reduce household and pet odors, assist you in keeping your family healthy and your friends and other visitors will be impressed at how nice your home looks.

Optical Brighteners

While optical brighteners can make a carpet appear cleaner, they have a harmful effect on carpet fibers. Technical people in the carpet industry have unanimously taken a stand against the use of brightening agents in the cleaning process. But, even with all of the adverse publicity, optical brighteners or color brighteners, as they are often called, are still used in some spot cleaning products, shampoo, dry-foam and extraction detergents.

Optical brighteners are actually dyes, which reflect the light and eventually cause yellowing in carpet fibers. For this reason alone, every legitimate carpet cleaning company should outlaw their use.

There is a false myth that cleaning a carpet before it is necessary will result in rapid resoiling.  Many years ago coconut oil shampoos were used for cleaning carpet and some of them did leave residues that resulted in rapid resoiling. Today almost all carpet cleaning products leave very little residue. The fact is that carpet in a typical household should be cleaned every 12 – 18 months depending on the number of people and pets living there and the amount of traffic. A good way to tell if a carpet is due for cleaning is by moving a chair or sofa so that the trafficked and non trafficked areas can be compared.

Professional Carpet Cleaners

While there are many do-it-your-self cleaning machines for purchase and rent, it is usually advisable to use a qualified professional carpet cleaner such as those Certified by the IICRC – Institute of Inspection, Cleaning and Restoration. A professional cleaner will have the experience that enables them to do a much better job than you can do yourself. The equipment they use has more extraction power than the units available to you, and the carpet will dry faster as well.  They know the cleaning agents to use, and they know the differences in carpet construction and fibers.

Doing it Yourself

If you have made the decision to rent a steam cleaning machine and do the job yourself, you should check on several systems before you make a selection.  Most of the units available for rent don’t clean well enough and may end up damaging your carpet.  Therefore, you should always consider the following:

• A number of rental companies offer cleaning equipment that is similar to what a professional will use.  You need equipment that has enough vacuum power to allow the carpet to dry rapidly, preferably in less than 12 hours.  It is best to avoid rental units found in many retail, hardware and grocery stores that don’t have the power to extract the cleaning solution from the carpet fast enough. Over wetting combined with slow drying can be damaging to a carpet.
• Avoid over wetting the carpet.  Prolonged dampness combined with traffic can cause a separation of the backing.  When a carpet remains wet for an extended period of time, this can lead to mildew growth and bacteria in the carpet backing.
• After cleaning your carpet place fans to increase air movement and speed the drying.
• Today most carpet has stain resistant treatments. Make sure that the carpet cleaning products you purchase are designed for the type of fiber you are cleaning. Failure to properly clean a carpet is action to void a stain resistant or carpet performance warranty.
• Never use cleaning or spotting solutions that contain bleaches as they can mess up the color of the carpet.
• Never use any silicone based treatments on the carpet. Silicone treatments are not needed and not designed for most of the carpet that is manufactured today.

A Comparison of Carpet Cleaning Systems

With all cleaning methods a wall to wall carpet needs to be thoroughly vacuumed prior to cleaning to remove any heavy soil such as silicates (the primary constituent of soil), without this pre-vacuuming, dirt and sand are forced to the backing of the carpet. It is highly recommended that you give your carpet a very thorough vacuuming prior to the arrival of the professional carpet cleaning company. While vacuuming make not of any special areas of concern and point these out to the cleaning crew upon its arrival.

Absorbent Powder / Dry Extraction Cleaning

An absorbent granular material that has been incorporated into a mixture of detergent, solvent and water is brushed into the carpet pile with a machine incorporating a double cylindrical brush.  Once the material has dried the carpet is vacuumed to remove the powder and the soil that it has captured. The best use for the absorbent powder cleaning method is the commercial installation where the carpet is cleaned regularly and requires quick drying.

Bonnet/Spin Pad

This method in appearance is similar to the rotary shampoo method. The machine used is essentially the same. A detergent is usually sprayed onto the carpet.  A rotating absorbent pad spins and agitates the carpet fibers as the soil is collected into the pad. This method improperly preferred on cut pile carpet can cause untwisting of the face pile. While this method is reasonably quick drying it must be done more often as it is more of a surface cleaning.  The best use for this method of cleaning is the commercial installation where they clean regularly and require quick drying.

Cylindrical Foam Shampoo

The cylindrical foam method uses a machine with an air compressor that whips the shampoo solution into heavy foam.  The foam is brushed into the carpet with a cylindrical brush. Once the carpet has dried it is vacuumed to remove the shampoo and the particles that have theoretically bonded to it. Not all of the shampoo and soil is actually captured but instead much of it is forced deeper into the pile. While this method is reasonably quick drying it must be done more often as it is more of a surface cleaning.  The best use for cylindrical foam cleaning is the commercial installation where they clean regularly and require quick drying.

Rotary Shampoo

The Rotary shampoo method uses chemicals similar to those used with cylindrical foam. The rotary floor machine usually has an attached solution tank for the shampoo solution.  The diluted solution is fed through a tub to a “shower-feed” where it is applied to the carpet.  While the shampoo is being applied a round brush on the machine is scrubbing the carpet.  This shampoo method uses more moisture than the cylindrical brush method. The rotary shampoo method is not recommended for use on cut pile carpet as it can cause untwisting of the face pile.

Steam Cleaning or Hot Water Extraction

With this method a non-foaming detergent is injected into the carpet fibers and is almost simultaneously vacuumed out of the carpet taking the dirt and soil with it. The extraction method when performed a skilled technician and quality chemicals will leave very little residue to attract to soil. You can use a truck mounted unit or a portable self contained unit as well. In the hands of an unskilled person a carpet can be over-wet during extraction cleaning so be sure to take extra dry passes when cleaning it yourself.

If you have concerns with the performance of your carpet it is suggested to have a thorough professional carpet cleaning prior to submitting a claim. While you cannot expect a 5 year old carpet to look brand new in traffic areas a Certified Carpet Inspector will be able to draw a fairer conclusion as to a carpets performance if they are inspecting a clean carpet.